Vibrating Feeder
Author: HXJQTime: 4/18/2013 6:00:10 PM
Feeder, it can send the massive, granular materials from storage silos uniformly and regularly to go to the affected device. In the sand and gravel production line, it can feed materials for crushing machinery continuously, and make coarse screening for materials. In the production process,vibrating feeder can send the massive, granular and powdery materials from the material storage warehouse or funnel uniform continuously or quantitatively to trenching equipment. They can be adjusted to the quantity, and make centralized control and automatic control of the production process. They can feed the conveyor, bucket elevator , screening equipment and the crusher, mill feed, as well as for automatic batching, packaging, and which can be automatically controlled process to achieve the automation of the production process. Hongxing is a good feeder manufacturer .
1.After check,vibrating
feeder machine and the
transmission part are normal, and they can start it;
2.Check the feeder and the exclude the conditions that if there are materials affecting the movement of the body, the debris of the body chute, spring and bracket.
3.Feeder downtime should process forward, to prohibit strip downtime or shutdown after the shutdown continues to feed.
4.After starting, if you found the vibrating feeder unusual phenomenon, and you should immediately stop the device. After identification and removal of irregularities, you can just make re-start.
5.Check that if feeder drive belt is good; you should replace it if found damage; if there is oil, wipe it with a rag.
Vibrating feeder - Security techniques:
Regular maintenance and repair are important means to extend the life of the machine, to ensure the normal work, the user should take it seriously. For lubrication, you should note the following:
1.The machine adopts thin oil splash lubrication, lubricants should be based on the place of use, the temperature conditions, it generally uses gear oil;
2.You should ensure that the oil level of exciter dilute is higher than the oil standard height (raise) through the joint elbow, every 3-6 months, oil must be replaced, oil change should adopt clean gasoline or kerosene to clean the tank, bearing raceways and the surface of the gear.
Security technology:
1.The operator of the machine should learn safety and technical education;
2.When operation, the nobody stands on the side, you should touch the device body,adjust and clean or repair it by hand.
3.Machinery and equipment should be near the grounded, wire insulation, and should be installed in a snakeskin tube, and always check the electrical wiring for wear and leakage,
